INSTRUCTIONS FOR REPLACEMENT SEAT COVERS Tools Needed: 1.Small flat blade screwdriver/Needle Nose Pliers/Utility Knife 2.Power or manual Stapler 3.1/4" to 3/16"Staples Removing the Old Seat Cover: Most seat covers are stapled to the plastic seat base. To remove them, you’ll need a small flathead screwdriver and a pair of needle-nose pliers. 1.Use the screwdriver to lift up each staple. 2.Grab the staples with the needle-nose pliers and pull them out. 3.Remove all the old staples and the original seat cover. If your seat foam is damp, place it in the sun for a day or two to dry. Finally, clean the seat base to prepare for installing the new cover. Installing the New Seat Cover: 1.Warm Up the Cover: Place the new seat cover in the sun or a warm area for 15-30 minutes to make it more flexible. 2.Position the Cover: Lay the cover over the seat, making sure it’s aligned correctly. Start at the front by centering the cover and wrapping it around the seat. Use 3-4 staples to hold it in place. 3.Secure the Back: Center the back of the seat and add 3-4 staples there. Then, pull the sides tight and staple 3-4 times on each side. 4.Adjust for Fit: Check how the cover fits. Focus on the tricky areas first by pulling the cover tight and stapling it down.Work out any wrinkles, and you might need to remove and redo some staples for a perfect fit. It can help to have a second person and be patient during this step. 5.Finish Up: Take your time to go around the cover until it fits nicely, ensuring it’s stapled all the way around.